First connect the STAN to the network using a TP (i.e. twisted pair) network cable with RJ-45 connectors. Ensure that the correct cabling is used and that a CNK 101 003 Ethernet Isolation Box is connected between the STAN and the network. If you want to connect STAN directly to the network port of a printer, without going e.g. through a switch or a network HUB, the Rx/Tx signals of the cable need to be crossed.
Start the STAN and …

USB devices that are to be used for transfer must be prepared through a special process. The purpose of this is to provide protection against unauthorised people taking recordings from STAN, intentionally or by mistake by plugging a memory stick, music player etc.. The preparation process only has to be performed once for a new storage device, before the first time it is used. Note that the act of preparing a storage device does not format it or delete any …

To calibrate the touchscreen, enter the Touchscreen Calibration dialog. This can be done either by selecting the Calibrate Touch button in the Maintenance Functions dialog as described above, or by touching the bottom left field stating Tap to calibrate touchscreen during start up. As with the service functions, the calibration dialog cannot be accessed while a temporarily ended recording is on the internal disk. In occurring cases, end the recording first by selecting the Start New button in the Continue …