How to configure STAN S31 for IP networking

First connect the STAN to the network using a TP (i.e. twisted pair) network cable with RJ-45 connectors. Ensure that the correct cabling is used and that a CNK 101 003 Ethernet Isolation Box is connected between the STAN and the network. If you want to connect STAN directly to the network port of a printer, without going e.g. through a switch or a network HUB, the Rx/Tx signals of the cable need to be crossed.
Start the STAN and …

Read more

How to update the STAN S31 system software

Software updates are generally supplied through the local distributor. Enclosed with each update is a detailed instruction on how to perform the update, and documentation relating to new and changed functions for the software. Contact your sales representative for further assistance.

Read more

How to transfer recordings to USB storage media

The following applies when STORAGE_DEVICE is set to USB Storage.
Anytime when the STAN is started, plug a prepared USB storage device into any of the two available USB connectors. It may be easier to do this with an USB extension cable. Note that it is possible to do this during an ongoing recording, without having to end it first.

When STAN identifies a prepared USB storage device, a confirmation dialog will first ask whether to start transfer recordings. …

Read more

# #